Westinghouse Oven Error F2
⚡ Quick Answer: The Westinghouse Oven F2 error indicates a malfunctioning temperature sensor, leading to incorrect temperature regulation and inconsistent cooking res... ✅ DIY Fixable
What Does Error F2 Mean?
The Westinghouse Oven F2 error indicates a malfunctioning temperature sensor, leading to incorrect temperature regulation and inconsistent cooking results. This error may cause the oven to beep or shut down heating functions, making it crucial to address promptly to restore proper operation.
Common Symptoms:
- F2 displayed on oven control panel
- Oven may beep or shut heating functions
- Temperature not regulated correctly
Possible Causes
- Faulty oven temperature sensor (high)
- Electronic oven control board issue (display/control board) (medium)
How to Fix Error F2
DIY Fix Perform basic checks and power reset
- Turn off oven and disconnect power at the mains/circuit breaker
- Wait a few minutes and restore power to clear potential temporary faults
- Observe if error code clears or reappears
Technician Only Inspect/replace temperature sensor
- Disconnect power and remove oven access panel
- Locate oven temperature sensor (usually inside oven cavity back wall)
- Test sensor resistance with a multimeter against manufacturer specifications
- Replace sensor if out of spec
- Reassemble and test oven for error resolution
Parts needed: oven temperature sensor
Technician Only Inspect and potentially replace control board
- Disconnect power and open control panel area
- Visually inspect control board for damage (burn marks, corrosion)
- Test signals from sensor to control board
- Replace control board (Electronic Oven Control) if faulty
Parts needed: electronic oven control board
- If error persists after power reset and basic checks
- If user is not comfortable with electrical component inspection
- If visible damage (burnt wiring/board) is found during inspection
Next step
Choose the next step for F2
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Temperature Sensor
Monitors the internal temperature to ensure correct operation and prevent overheating.
- Typical part-only price
- $15 - $35
- DIY difficulty
- Easy
- Estimated time
- 15-30 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Main Control Board
The central brain of the appliance that controls all components, cycles, and timings.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | N/A |
|---|---|
| component | Temperature Sensor |
| resistance | 1,000-1,500 ohms |
| part_number | WB21X5301 |
| voltage_rating | 120V AC |
Common Questions
What does F2 error mean on Westinghouse Oven?
F2 indicates a faulty temperature sensor, causing erratic temperature readings.
Can I fix Westinghouse Oven F2 error myself?
Yes, try performing a power reset and basic checks to see if the error clears.
How much does it cost to fix F2 error?
Repair costs range from $30 to $120 for parts and labor.
When should I call a technician for F2?
Call a technician if the error persists after a reset or if you notice visible damage.
Sources & References
Data last verified: 2026-07-22
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!