Sharp Air Purifier Error E01

⚡ Quick Answer: The Sharp Air Purifier E01 error indicates a malfunction in the filter sensor, often signaled by a blinking display light. This may cause the unit to ... ✅ DIY Fixable

What Does Error E01 Mean?

The Sharp Air Purifier E01 error indicates a malfunction in the filter sensor, often signaled by a blinking display light. This may cause the unit to stop functioning normally. To resolve this issue, check that the filters are properly installed and clean. Resetting the filter indicator may also help. If problems persist, further inspection may be needed.

Common Symptoms:

  • Display shows E01 and unit may stop or not operate normally (general observation in appliance error codes, not confirmed for all Sharp air purifiers)

Possible Causes

  • Filter Sensor

How to Fix Error E01

DIY Fix Basic checks and maintenance

  1. Unplug the air purifier from the power outlet and wait about 30 seconds.
  2. Check that the filters are properly installed and not heavily soiled.
  3. If your model has a filter reset or maintenance indicator button, consult the specific manual to reset it after cleaning or replacing filters.

Technician Only Service inspection

  1. Refer to the exact model’s official service manual or contact Sharp support with the model number for precise error code definitions.
  2. Inspect sensors, control board communications, and filter detection circuitry if applicable.
  3. Replace parts only if confirmed by official Sharp documentation or diagnostic results.

Parts needed: filter units, sensor assemblies, control board (model dependent)

🛑 When to Call a Pro:
  • If the error persists after cleaning/replacing filters and performing the basic reset procedure documented for your model.
  • If there are unusual noises, odors, or smoke accompanying the error display.
  • If filters and covers appear damaged or sensors seem malfunctioning.

Technical Specifications

wattage 50W
component Filter Sensor
resistance N/A
part_number SHARP-HEPA-FILTER-2023
voltage_rating 120V AC

Common Questions

What does E01 error mean on Sharp Air Purifier?

E01 indicates a malfunction in the filter sensor, often accompanied by a blinking display light.

Can I fix Sharp Air Purifier E01 error myself?

Yes, try checking the filter installation, cleaning, and resetting the filter indicator.

How much does it cost to fix E01 error?

Repair costs vary by region and part; filter and sensor replacements are generally minimal, while control board costs are higher.

When should I call a technician for E01?

Call if the error persists after basic troubleshooting, or if you notice unusual noises, odors, or visible damage.

Sources & References

Data last verified: 2026-03-18

User Comments (0)

Share your experience or solution below.

Be the first to comment!