Roper Washing Machine Error F8E1

⚡ Quick Answer: The Roper washing machine error F8E1 signals a malfunction in the water level sensor, indicating a long fill or low water detection issue. This result... ✅ DIY Fixable

What Does Error F8E1 Mean?

The Roper washing machine error F8E1 signals a malfunction in the water level sensor, indicating a long fill or low water detection issue. This results in the washer either filling very slowly or not at all, preventing the cycle from starting due to insufficient water. Users may notice the error code displayed or experience a timeout before the wash initiates.

Common Symptoms:

  • Washer displays F8E1 or LO FL error
  • Washer fills very slowly or not at all
  • Cycle may not start due to insufficient water detection
  • Could time out before wash begins

Possible Causes

  • Insufficient water supply (medium)
  • Clogged inlet screens or hoses (medium)
  • Faulty water inlet valve (medium)

How to Fix Error F8E1

DIY Fix Check basic water supply and hoses

  1. Ensure both hot and cold water faucets are fully open.
  2. Inspect inlet hoses for kinks, twists, or visible damage.
  3. Disconnect hoses, then run water into a bucket to confirm adequate flow.

DIY Fix Clean inlet screens

  1. Turn off water supply at the wall.
  2. Disconnect the inlet hoses from the washer.
  3. Use a small brush or toothbrush to clean debris from the small screens in the inlet valve.
  4. Reconnect hoses and test fill.

Technician Only Test and replace water inlet valve if needed

  1. Verify water pressure and flow at the valve with a multimeter and water pressure gauge.
  2. If valves do not allow adequate flow when energized or screens are not serviceable, replace the water inlet valve assembly.

Parts needed: Water inlet valve assembly

🛑 When to Call a Pro:
  • If basic supply checks and inlet screen cleaning do not resolve the error
  • If water inlet valve replacement does not clear the error
  • If there’s suspected internal wiring or sensor failure

Technical Specifications

wattage N/A
component Water Level Sensor
resistance 1k-3k ohms
part_number W10415587
voltage_rating 120V AC

Common Questions

What does F8E1 error mean on Roper washing machine?

F8E1 indicates a low water detection issue, preventing proper filling during cycles.

Can I fix Roper washing machine F8E1 error myself?

Yes, check water supply, hoses for kinks, and clean inlet screens.

How much does it cost to fix F8E1 error?

Estimated repair costs range from $50 to $150 for parts, plus labor.

When should I call a technician for F8E1?

Call if the issue persists after basic checks or if there's suspected internal failure.

Sources & References

Data last verified: 2026-03-25

User Comments (0)

Share your experience or solution below.

Be the first to comment!