Omega Dishwasher Error i30

⚡ Quick Answer: The Omega Dishwasher error code i30 indicates a water leakage detection issue. This error is typically triggered when water is detected in the base of... ✅ DIY Fixable

What Does Error i30 Mean?

The Omega Dishwasher error code i30 indicates a water leakage detection issue. This error is typically triggered when water is detected in the base of the appliance, leading to a mid-cycle stop, continuous beeping, and flashing error lights. Common causes include an internal water leak or an overflow condition. To address this, inspect the door gasket for damage, check for any water accumulation, and ensure that the drain and filter areas are clear of debris.

Common Symptoms:

  • Dishwasher stops mid‑cycle
  • Error code i30 displayed
  • Possible water accumulation detected at base or internal leak detected
  • Drain pump may run continuously in some cases

Possible Causes

  • Internal water leak or water detected in base (low)

How to Fix Error i30

DIY Fix Basic checks for potential leak conditions

  1. Turn off water supply to the dishwasher.
  2. Visually inspect around and under the dishwasher for signs of water leakage.
  3. Check door gasket/seal for cracks, damage, or debris.
  4. Ensure dishwasher is level and no hoses are kinked or loose.

DIY Fix Check drainage and filters

  1. Open dishwasher and remove bottom rack.
  2. Locate and clean any debris from the filter and drain area.
  3. Verify that the drain hose is not bent or clogged.
  4. Run a short cycle to see if error reoccurs after these steps.

Technician Only Inspect internal leak sensor and water collection tray

  1. Disconnect dishwasher from power and water supply.
  2. Remove access panels to check the internal water collection tray for moisture.
  3. Inspect and test the leak/flood sensor for proper operation.
  4. Check for ruptured hoses, loose connections, or cracked components that could cause leaks and replace as needed.

Parts needed: Leak/flood sensor, Hoses and connectors, Door gasket/seals

🛑 When to Call a Pro:
  • If water leak is significant or source cannot be identified by basic checks
  • If error persists after cleaning drains and inspecting seals
  • If internal components (sensors, pumps) need to be tested/replaced

Technical Specifications

wattage 1500W
component Float Switch
resistance 5-10 ohms
part_number Omega 123456
voltage_rating 120V AC

Common Questions

What does i30 error mean on Omega Dishwasher?

The i30 error indicates a water leak detection issue, causing the dishwasher to stop mid-cycle.

Can I fix Omega Dishwasher i30 error myself?

Yes, you can perform basic checks for leaks and clean the drain and filter.

How much does it cost to fix i30 error?

Repair costs range from $100 to $300, depending on parts and labor needed.

When should I call a technician for i30?

Contact a technician if leaks are significant or if the error persists after your checks.

Sources & References

Data last verified: 2026-04-23

User Comments (0)

Share your experience or solution below.

Be the first to comment!