Monogram Dishwasher Error LEAK-DETECTED
⚡ Quick Answer: The Monogram Dishwasher LEAK-DETECTED error signifies that the appliance's leak detection system has identified water in the base pan, halting normal ... ✅ DIY Fixable
What Does Error LEAK-DETECTED Mean?
The Monogram Dishwasher LEAK-DETECTED error signifies that the appliance's leak detection system has identified water in the base pan, halting normal operation. Symptoms include water pooling beneath the unit, cancellation of the current cycle, and continuous drain pump activity. This issue may arise from various causes such as a faulty door gasket, damaged hoses, or a clogged drain. Immediate inspection and removal of any standing water are crucial to prevent further damage.
Common Symptoms:
- Dishwasher cancels current cycle when the message appears.
- Water or moisture present in the base pan beneath the dishwasher.
- Continuous drain pump operation after detection.
- Visible water on kitchen floor near dishwasher.
Possible Causes
- Actual water leak in base pan beneath dishwasher (e.g., hose, pump, seal failure) (medium)
- Faulty or worn door gasket or seal allowing water to escape during cycles (medium)
- Clogged or damaged drain/overflow leading to water escape (medium)
How to Fix Error LEAK-DETECTED
DIY Fix Inspect for visible leaks and remove water from base
- Turn off power to the dishwasher (unplug or shut off circuit breaker).
- Pull dishwasher out and check for water under the unit (base pan).
- Use towels or a wet/dry vacuum to remove water from the base pan area.
- Check around door seals and under the unit for any obvious leaks.
Technician Only Diagnose and repair internal leak source
- Inspect and replace damaged door gasket or threshold seal if worn or cracked.
- Check water inlet and drain hoses for cracks or loose connections and replace if needed.
- Inspect pump and motor assembly for leaks; replace faulty parts.
- Verify leak/flood switch and sensor wiring connections; replace sensor if defective.
Parts needed: Door gasket/seal, Drain hose, Water inlet hose/valve, Leak/flood sensor, Pump/motor assembly
- If you cannot locate the source of the leak after basic inspection.
- If visible structural damage (cracked tub, cracked hoses) is found.
- If water continues to accumulate after removing water from the base pan.
Next step
Choose the next step for LEAK-DETECTED
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Door Gasket
Creates a watertight seal around the door to prevent leaks during operation.
- Typical part-only price
- $45 - $110
- DIY difficulty
- Medium
- Estimated time
- 30-60 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other parts options
Check related components first; use model search as a fallback.
Drain Hose
Carries waste water from the drain pump to your home's standpipe or sink drain.
Water Supply Hose
Connects your home water valves to the water inlet valve on the appliance.
Float Switch
Detects the maximum water level to prevent overflow and potential flooding.
Model-compatible Dishwasher parts
Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Optional routine care
Maintenance supplies
These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.
Dishwasher Cleaner and Descaler
Supports routine removal of mineral scale, grease, and odor. It is maintenance, not a repair for a failed pump, valve, or control.
Braided Dishwasher Inlet Hose
For replacement of an externally damaged supply hose. Verify connection size, length, and appliance installation requirements before ordering.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.
Technical Specifications
| wattage | 60W |
|---|---|
| component | Water Inlet Valve |
| resistance | 10-20 ohms |
| part_number | WD15X10003 |
| voltage_rating | 120V AC |
Common Questions
What does LEAK-DETECTED error mean on Monogram Dishwasher?
It indicates a detected leak, causing the appliance to stop operation and may result in water pooling at the base.
Can I fix Monogram Dishwasher LEAK-DETECTED error myself?
Yes, you can inspect for visible leaks and remove water from the base pan after turning off the power.
How much does it cost to fix LEAK-DETECTED error?
Estimated repair costs range from $150 to $600, depending on the specific parts and labor needed.
When should I call a technician for LEAK-DETECTED?
Call a technician if you cannot locate the leak, notice structural damage, or if water continues to accumulate.
Sources & References
Data last verified: 2026-07-22
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!