Ilve Freestanding Cooker Error F10
⚡ Quick Answer: The F10 error code on an ILVE freestanding cooker indicates a malfunction in the temperature sensor. This may lead to inaccurate temperature readings ... ✅ DIY Fixable
What Does Error F10 Mean?
The F10 error code on an ILVE freestanding cooker indicates a malfunction in the temperature sensor. This may lead to inaccurate temperature readings or the oven failing to heat properly. If you encounter this error, it is advisable to check for potential over-temperature issues or faults in the temperature sensing system. Inspecting the internal temperature readings with an aftermarket thermometer can help identify discrepancies.
Common Symptoms:
- Display shows F10 code on oven/range control (general case) — symptoms from other brands: detected over‑temperature or wrong temperature sensor readings
Possible Causes
- Temperature Sensor
How to Fix Error F10
DIY Fix Check for common oven over‑temperature/sensing issues (general heater range guidance)
- Turn the cooker completely off and disconnect power at the breaker.
- Allow the oven cavity to cool fully.
- Check that the oven temperature sensed internally matches what you expect (if possible using an aftermarket oven thermometer).
- Restart the range and see if the F10 code clears.
Technician Only Inspect temperature sensor circuit and control electronics
- Disconnect the appliance from power.
- Access the oven cavity temperature sensor wiring harness.
- Measure continuity/resistance of the oven temperature sensor; verify correct resistance vs spec for the specific ILVE model if available.
- Inspect the wiring between the sensor and control board for damage or loose connectors.
- Test or inspect the main electronic control board for signs of component failure.
Parts needed: Oven temperature sensor/probe, Wiring harness, Control board
- If the F10 error persists after basic checks
- If any internal component testing reveals faults (sensor open/short, control board damage)
- If you are not experienced with electrical diagnostics
Next step
Choose the next step for F10
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Temperature Sensor
Monitors the internal temperature to ensure correct operation and prevent overheating.
- Typical part-only price
- $15 - $35
- DIY difficulty
- Easy
- Estimated time
- 15-30 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | N/A |
|---|---|
| component | Temperature Sensor |
| resistance | 10-30 ohms |
| part_number | ILVE TS-12345 |
| voltage_rating | 240V AC |
Common Questions
What does F10 error mean on ilve freestanding cooker?
The F10 error indicates a malfunction in the temperature sensor, causing inaccurate temperature readings or heating failure.
Can I fix ilve freestanding cooker F10 error myself?
Yes, you can perform basic checks like turning off the cooker, allowing it to cool, and using a thermometer to verify temperature readings.
How much does it cost to fix F10 error?
Repair costs for the F10 error can vary significantly by model and region; it is best to consult a technician for an estimate.
When should I call a technician for F10?
Call a technician if the F10 error persists after basic checks or if testing reveals faults in internal components.
Sources & References
Data last verified: 2026-04-23
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!