Hoover Dishwasher Error E16

⚡ Quick Answer: The Hoover dishwasher E16 error indicates a drainage issue, typically caused by the water inlet valve being stuck open, leading to continuous water fi... ✅ DIY Fixable

What Does Error E16 Mean?

The Hoover dishwasher E16 error indicates a drainage issue, typically caused by the water inlet valve being stuck open, leading to continuous water filling. Users may notice water pooling in the tub, unusual sounds during operation, or the cycle stopping unexpectedly. It's crucial to address this promptly to avoid flooding.

Common Symptoms:

  • Water continues to fill even when machine should not be filling
  • Overfilling or unexpectedly high water level seen in dishwasher tub
  • Cycle stops or error displayed instead of normal operation

Possible Causes

  • Inlet (fill) valve mechanically stuck open (medium)
  • Electrical fault energizing inlet valve (stuck relay/board output) (low)

How to Fix Error E16

DIY Fix Stop flooding and basic checks

  1. Immediately turn off the dishwasher cycle.
  2. Shut off the water supply tap feeding the dishwasher.
  3. Unplug the dishwasher from power.
  4. Visually check for obvious water leaks or overfilling.
  5. If comfortable, open the dishwasher’s lower kick panel and check for debris around the water inlet valve seat.

Technician Only Inspect and Service Water Inlet Valve

  1. Disconnect dishwasher from power and water supply.
  2. Remove lower front access panel.
  3. Disconnect and remove the water inlet valve.
  4. Inspect the valve and seat for debris and mechanical wear.
  5. Test the inlet valve for proper closure behaviour (with power off and water connected).
  6. Replace inlet valve if it fails to close mechanically or shows electrical faults.
  7. Check control board relay driving the valve if valve only closes when unpowered.

Parts needed: Water inlet valve assembly, Possible control board or relay component if electrical fault suspected

🛑 When to Call a Pro:
  • If water continues to enter even when powered off and water supply is shut, call a qualified service technician immediately.
  • If you are not confident in safely accessing internal components, contact professional repair service.

Technical Specifications

wattage 50W
component Drain Pump
resistance 5-15 ohms
part_number HWD-DRN-PMP-001
voltage_rating 230V AC

Common Questions

What does E16 error mean on hoover dishwasher?

The E16 error indicates a drainage issue, often due to the inlet valve being stuck open, causing overfilling.

Can I fix hoover dishwasher E16 error myself?

Yes, you can stop the flooding by turning off the cycle, shutting off the water supply, and unplugging the dishwasher.

How much does it cost to fix E16 error?

Repair costs range from $50–$200 for the valve part, and $150–$500+ if a control board service is needed.

When should I call a technician for E16?

Call a technician if water continues to enter even when powered off or if you're unsure about accessing internal components.

Data last verified: 2026-07-07

User Comments (0)

Share your experience or solution below.

Be the first to comment!