LG Washer Dryer: clogged water outtake

Possible Causes

Clogged drain hose or hose kinked

How to Identify: Water backs up in drum; visible kinks or bends in hose; slow drainage when tested.

Part: Drain hose

Blockage in drain filter or pump inlet

How to Identify: Visible debris in filter housing, lint buildup; water doesn’t drain even if hose is clear.

Part: Drain pump filter/pump inlet

Drain path clog at home plumbing or sink trap

How to Identify: Drainage slow from other home fixtures; water drains slowly from washer but clears when hose tested externally.

Part: Home drain/trap

Faulty drain pump or internal motor issue

How to Identify: Unusual noises from pump, burning smell, or no pump activity when draining is commanded.

Part: Drain pump

DIY Solutions

Inspect and straighten drain hose

Easy 10 minutes

Tools Needed: none

1. Disconnect washer from power and move to access back.
2. Inspect the drain hose for kinks or bends and straighten them.
3. Check for obstructions by flushing hose with water or using a flexible brush.
4. Reconnect hose and test drain.

⚠️ Safety First: Always unplug before accessing hoses

Clean drain filter and accessible pump inlet

Moderate 20-30 minutes

Tools Needed: screwdriver, bucket, towels

1. Unplug unit and locate drain filter access panel (lower front).
2. Place bucket beneath and open filter cap to drain residual water.
3. Remove visible lint and debris from filter and inlet.
4. Replace filter securely, reconnect power and test drain.

⚠️ Safety First: Be prepared for water spill

Clear home drain trap

Moderate 15-45 minutes

Tools Needed: plumbing snake or drain brush, bucket

1. Remove drain hose from home connection.
2. Use plumbing snake or brush to clear house drain/trap.
3. Reattach hose and run a drain test cycle.

⚠️ Safety First: Wear gloves; ensure proper sanitation

Next step

Choose the next step for clogged water outtake

Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.

Based on diagnostic data

Most relevant component to inspect

Drain Hose

Carries waste water from the drain pump to your home's standpipe or sink drain.

Typical part-only price

$15 - $30

DIY difficulty

Easy

Estimated time

15-30 mins

Optional: enter your model number

Apply

Where can I find the model number?

Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.

Find a part that fits my model

Verify the complete model and part number on the retailer's compatibility page before ordering.

Other parts options

Check related components first; use model search as a fallback.

Possible related component

Drain Pump

Pumps waste water out of the appliance during the drain cycle.

$35 - $80 · Easy · 15-30 mins

Check fit & price

Model number required

Model-compatible Washer Dryer parts

Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.

Find a part that fits my model

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.

Optional routine care

Maintenance supplies

These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.

Maintenance supply

Dryer Vent Cleaning Kit

Helps remove routine lint buildup from an accessible dryer vent path. It does not diagnose or repair an E-code or failed component.

View maintenance supply

Maintenance supply

Lint Trap Cleaning Brush

A narrow brush for routine cleaning around an accessible lint screen and housing.

View maintenance supply

Maintenance supply

Dryer Vent Hose Kit

A replacement exhaust duct option for visibly crushed or damaged external venting. Check diameter, length, local code, and installation clearance.

View maintenance supply

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.

Professional Repairs

Replace malfunctioning drain pump

Estimated Cost: $80 - $200

Internal hose/pump assembly deep cleaning service

Estimated Cost: $100 - $250

When to Call a Professional

Water remains after clearing external clogs and filters

Unusual noises from pump motor

Repeated clogging despite cleaning attempts

Preventive Maintenance

• Clean drain filter: Build-up of lint and debris that lead to drainage clogs
  Frequency: monthly
• Check and straighten drain hose: Hose kinks that impede drainage
  Frequency: quarterly

Frequently Asked Questions

Why is my LG Washer Dryer clogged water outtake?

Common causes include a clogged drain hose, blockage in the drain filter, or a faulty drain pump.

How do I fix LG Washer Dryer clogged water outtake myself?

Inspect the drain hose for kinks, clean the drain filter, and clear any blockages in your home plumbing.

How much does it cost to fix clogged water outtake?

Professional repairs for a malfunctioning drain pump can cost between $80 and $200.

When should I call a technician for clogged water outtake?

If DIY solutions don't resolve the issue, or if you suspect a faulty pump or internal problem, it's best to consult a professional.

References & Sources

• LG Washing Machine Water Not Draining Official

Common Issues Reported by Users

• Small items getting clogged in water outtake section (2 mentions)

User Suggested Solutions

1. Use laundry bags for small items