Grundig Washing Machine: not spinning, strange clicking noise
What is this symptom?
If your Grundig washing machine is not spinning and making a strange clicking noise, it could indicate an unbalanced load or foreign objects in the drum. The drum may barely move, leaving your clothes wet at the end of the cycle. This problem requires attention to avoid further damage.
Possible Causes
Unbalanced Load or Load Distribution
How to Identify: Noise occurs shortly after spin begins; machine shakes or rocks; distribution of clothes is uneven.
Part: Drum and load sensors
Foreign Objects in Drum or Pump
How to Identify: Intermittent clicking that sounds like banging or rattling; often coincides with visible small objects in drum or pump area.
Part: Drain pump and drum area
Worn Drum Bearings
How to Identify: Rumbling or grinding noise intensifies with drum spin; manual rotation feels rough.
Part: Drum bearings
Next step
Choose the next step for not spinning, strange clicking noise
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Drain Pump
Pumps waste water out of the appliance during the drain cycle.
- Typical part-only price
- $35 - $80
- DIY difficulty
- Easy
- Estimated time
- 15-30 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Drum Bearing Kit
Supports the spinning drum and ensures smooth, quiet rotation during cycles.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Preventive Maintenance
-
Regularly check and balance loads: Unbalanced loads and spin cycle issues
Frequency: Every wash -
Inspect drum and pockets for small objects: Foreign object noises and possible damage
Frequency: Weekly
Frequently Asked Questions
Why is my Grundig Washing Machine not spinning, strange clicking noise?
How do I fix Grundig Washing Machine not spinning, strange clicking noise myself?
How much does it cost to fix not spinning, strange clicking noise?
When should I call a technician for not spinning, strange clicking noise?
References & Sources
Community Analytical Insights
Analysis based on real user discussions from appliance repair communities
Can I Fix This Myself?
Common Issues Reported by Users
- Faulty motor coupling or drive belt issue
- Blocked or jammed drain pump
- Corrupted connection from motor to logic board
User Suggested Solutions
-
Inspect and replace the motor coupling or drive belt. Disconnect the washing machine from power, remove the back panel, and check the motor coupling for wear or damage. If damaged, replace it with a new one.
-
Check and clear the drain pump. Disconnect the power and remove the front panel to access the drain pump. Inspect for clogs or debris and clean as necessary.
-
Repair the connection from the motor to the logic board. Ensure the washing machine is unplugged, then check the wiring harness for loose or damaged connections. Reconnect or replace as needed.
Analysis based on 1 community discussions
View
Sources
Data compiled from real discussions on r/appliancerepair and r/Appliances:
Community Discussions
makes strange sound and does not wash properly, especially it won't spin at the end of the washing program; strange clicking noise from the motor unit
The connection from the motor to the logic board was corrupted.
Source: Reddit r/appliancerepair
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!