Bosch Dishwasher: E15 error code
What is this symptom?
Experiencing the Bosch Dishwasher E15 error code? This indicates that the anti-flood safety system has detected unwanted water accumulation in the base tray, causing your dishwasher to halt mid-cycle. To prevent flooding, the error will persist until the water is removed and the system is reset.
Important Tips for Bosch Models
- E15 code specifically indicates activation of Bosch’s anti‑flood/leak detection system
- Bosch recommends contacting customer support when E15 appears due to leak detection
Possible Causes
Water accumulation in base pan triggering flood detection system
How to Identify: E15 error code displayed; water detected under dishwasher when tilt or panel removed; float/safety switch triggered. (åšä¸–家电
Part: Base pan/leak sensor (E15 safety switch)
Excessive suds/incorrect detergent causing overflow
How to Identify: Visible excessive suds; point of use wrong detergent type or too much detergent used. (åšä¸–家电
Part: Dishwasher detergent system/suds management
Clogged filters or blocked drainage causing water back‑up
How to Identify: Slow or no drainage, standing water in tub after cycle, E15 triggered. (Best Buy Blog
Part: Drain filter, drain pump, hoses
Worn/defective door seal or gasket leak
How to Identify: Water around door edges after cycle, visible seal wear or cracks. (åšä¸–家电
Part: Door seal/gasket
Internal leak from hoses, sump basin, inlet valve
How to Identify: Consistent water pooling under machine despite resets; visible drips when inspecting internal parts. (åšä¸–家电
Part: Hoses, sump basin, inlet valve
DIY Solutions
Clear water from base and reset E15 safety switch
- Disconnect dishwasher from power and water.
- Remove lower kickplate/panel to access base pan.
- Mop up standing water in base pan and dry thoroughly.
- Locate E15 safety float/switch; remove/clean and reposition float.
- Reassemble and reconnect power; run short cycle to test.
Clean drain filter and check for drainage blockages
- Remove bottom rack.
- Locate and remove drain filter; clean debris.
- Inspect visible drain hose entry for blockages.
- Reinstall filter and run drain cycle.
Check and replace door gasket
- Disconnect power.
- Open dishwasher door and inspect gasket.
- Remove old gasket and install new approved gasket.
- Ensure proper seating and run test cycle.
Professional Repairs
Repair or replace internal leak sources (hoses, sump, inlet valve)
Replace E15 leak sensor/safety switch
When to Call a Professional
Preventive Maintenance
-
Clean filters and check seals: Drain blockages and minor leaks
Frequency: monthly -
Inspect hoses and connections: Internal hose leaks leading to E15 error
Frequency: annually
Frequently Asked Questions
Why is my Bosch Dishwasher E15 error code?
How do I fix Bosch Dishwasher E15 error code myself?
How much does it cost to fix E15 error code?
When should I call a technician for E15 error code?
References & Sources
- Bosch Dishwasher E15 Error Code FAQ Official
- E15 Code on Your Bosch Dishwasher: A Quick Fix Guide Repair-Blog
Community Analytical Insights
Analysis based on real user discussions from appliance repair communities
Can I Fix This Myself?
Common Issues Reported by Users
- Water inlet valve malfunction (1 mentions)
- Issues with diverter or seals (1 mentions)
User Suggested Solutions
-
Replaced the water inlet valve, inlet water line, and drain hose
-
Investigate diverter, seal, and filter for potential issues
Analysis based on 2 community discussions
View
Sources
Data compiled from real discussions on r/appliancerepair and r/Appliances:
Community Discussions
E15 error code
Replaced the water inlet valve, inlet water line, and drain hose; resolved the E15 error.
Source: Reddit r/appliancerepair
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!