Blomberg Washer Dryer: leaking
What is this symptom?
If your Blomberg Washer Dryer is leaking water during any cycle, it can be frustrating. Leaks may occur from the door, bottom, rear, or hoses and could arise during filling, washing, draining, or spinning. Common causes include damaged hoses, loose clamps, or worn door seals. Identifying and addressing the source promptly can prevent water damage and ensure optimal performance.
Important Tips for Blomberg Models
- Blomberg washer dryers commonly leak from internal hoses or pump housings; repeated reports of loose/clamped hoses needing tightening. (
Possible Causes
Damaged or loose drain/inlet hoses
How to Identify: Water pooling near floor during fill or drain; visible cracks, bulges, or loose connections on hoses
Part: Drain hose / water inlet hose
Loose hose clamps or connections at pump or tub
How to Identify: Spray or trickle of water from hose joints during operation; tightening clamps stops leak temporarily
Part: Hose clamps and connectors
Worn or torn door boot seal (gasket)
How to Identify: Water around front door seal after or during cycle; visible tears or soft spots in gasket
Part: Door boot seal (rubber cuff)
Leaking drain pump housing
How to Identify: Water pooling beneath machine or rear bottom; leak appears to originate near pump body
Part: Drain pump
Detergent drawer overflow or clog
How to Identify: Water spilling from detergent drawer during fill; buildup visible in drawer ports
Part: Detergent drawer and internal paths
DIY Solutions
Inspect and Replace Leaky Hoses
- Turn off and unplug machine, shut off water supply
- Pull unit forward and inspect inlet and drain hoses for cracks or wear
- Loosen clamps, remove damaged hose, replace with matching part
- Secure new hose with clamps ensuring tight fit and proper routing
Tighten or Replace Hose Clamps
- Unplug and access rear/lower panel
- Locate loose hose clamps on tub-to-pump or inlet hoses
- Tighten clamps securely or replace with new spring/screw clamps
- Run short cycle to confirm leak is fixed
Clean and Reseat Detergent Drawer
- Pull out detergent drawer
- Rinse out detergent and fabric softener pockets
- Remove any soap buildup in channels
- Slide drawer back in and run rinse checking for leaks
Next step
Choose the next step for leaking
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Drain Hose
Carries waste water from the drain pump to your home's standpipe or sink drain.
- Typical part-only price
- $15 - $30
- DIY difficulty
- Easy
- Estimated time
- 15-30 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other parts options
Check related components first; use model search as a fallback.
Water Supply Hose
Connects your home water valves to the water inlet valve on the appliance.
Door Gasket
Creates a watertight seal around the door to prevent leaks during operation.
Drain Pump
Pumps waste water out of the appliance during the drain cycle.
Model-compatible Washer Dryer parts
Enter the complete model number to browse compatible replacement parts. This is a model-based parts search, not a diagnosis that a specific component failed.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Optional routine care
Maintenance supplies
These products support cleaning or routine upkeep. They are separate from the possible repair components above and are not claimed to fix this error code or symptom.
Dryer Vent Cleaning Kit
Helps remove routine lint buildup from an accessible dryer vent path. It does not diagnose or repair an E-code or failed component.
Lint Trap Cleaning Brush
A narrow brush for routine cleaning around an accessible lint screen and housing.
Dryer Vent Hose Kit
A replacement exhaust duct option for visibly crushed or damaged external venting. Check diameter, length, local code, and installation clearance.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Recommendations are based on routine-care relevance, not commission rate.
Professional Repairs
Replace Door Boot Seal
Drain Pump Replacement
Internal Leak Diagnosis and Seal Replacement
When to Call a Professional
Preventive Maintenance
-
Inspect hoses and clamps: Leak due to hose wear or loose connections
Frequency: annually -
Clean detergent drawer: Overflow spills and buildup leading to leaks
Frequency: monthly
Frequently Asked Questions
Why is my Blomberg Washer Dryer leaking?
How do I fix Blomberg Washer Dryer leaking myself?
How much does it cost to fix leaking?
When should I call a technician for leaking?
References & Sources
Community Analytical Insights
Guidance from available sources; statistical claims are shown only for samples of at least 10 discussions
Common Issues Reported by Users
- Worn or damaged door seal/gasket
- Clogged or damaged drain pump
- Loose or damaged hoses (inlet or drain)
User Suggested Solutions
-
Inspect and replace the door seal/gasket. Ensure the door is closed properly and check for any tears or debris. If damaged, replace with a new seal.
-
Check the drain pump for clogs or damage. Remove the drain filter and clean any debris. If the pump is damaged, replace it.
-
Inspect all hoses for leaks or damage. Tighten any loose connections and replace damaged hoses.
Limited-source guidance; percentages and success-rate claims are not shown
View
Sources
Data compiled from real discussions on r/appliancerepair and r/Appliances:
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!