Fisher & Paykel Dryer Error E4
⚡ Quick Answer: The Fisher & Paykel dryer error E4 indicates a heater element or heater circuit fault, resulting in insufficient heat during the drying cycle. This ca... ✅ DIY Fixable
What Does Error E4 Mean?
The Fisher & Paykel dryer error E4 indicates a heater element or heater circuit fault, resulting in insufficient heat during the drying cycle. This can cause your clothes to remain damp or cold as the dryer operates normally without generating the necessary heat. The issue may arise from an open or failed heater element, damaged wiring, or a faulty heater relay within the control board.
Common Symptoms:
- Dryer runs normally but clothes remain damp or cold
- No or insufficient heat during cycle
Possible Causes
- Open or failed heater element (medium)
- Damaged wiring or connectors in heater circuit (medium)
- Faulty heater relay or associated control board component (low)
How to Fix Error E4
DIY Fix Preliminary checks before service call
- Ensure lint filter and vents are clean to avoid airflow issues.
- Verify that dryer actually isn’t heating by feeling exhaust air temperature mid-cycle.
Technician Only Test and replace heater-related components
- Disconnect power and access heater assembly.
- Measure resistance across heater element; replace if open.
- Inspect heater circuit wiring and connectors; repair or replace as needed.
- If heater and wiring are good, test heater relay on control board and replace board if necessary.
Parts needed: Heater element assembly, Wiring harness and connectors, Control board (heater relay section)
- If error persists after basic user-level checks
- If internal electrical testing or part replacement is required
Next step
Choose the next step for E4
Confirm the diagnosis before ordering. An error code can identify the system involved, but it does not prove that a specific part has failed.
Most relevant component to inspect
Heating Element
Heats the water or air inside the appliance to the required temperature.
- Typical part-only price
- $40 - $95
- DIY difficulty
- Medium
- Estimated time
- 30-45 mins
Where can I find the model number?
Check the rating label around the door, lid, frame, rear panel, or inside the appliance cabinet. Use the complete model number, including suffixes.
Verify the complete model and part number on the retailer's compatibility page before ordering.
Other components that may be involved
Check these only if your diagnosis points to them.
Main Control Board
The central brain of the appliance that controls all components, cycles, and timings.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. We may earn a commission from other qualifying purchases or service requests made through links on this page, at no additional cost to you. Recommendations are based on repair relevance, not commission rate.
Technical Specifications
| wattage | 5000W |
|---|---|
| component | Thermal Fuse |
| resistance | 0 ohms (continuity) |
| part_number | WH12X10462 |
| voltage_rating | 240V AC |
Common Questions
What does E4 error mean on fisher & paykel dryer?
The E4 error indicates a heater element fault, leading to insufficient heat and damp clothes.
Can I fix fisher & paykel dryer E4 error myself?
Yes, you can perform preliminary checks like cleaning the lint filter and verifying the exhaust air temperature.
How much does it cost to fix E4 error?
The estimated repair cost ranges from $150 to $450, depending on the necessary parts.
When should I call a technician for E4?
Call a technician if the error persists after basic checks or if internal testing is needed.
Sources & References
- F&P Dryer Fault Codes (general support page) (official)
Data last verified: 2026-07-25
User Comments (0)
Share your experience or solution below.
Please login to post a comment.
Be the first to comment!